displayit Graffiti:Plus Wall - Kit A Assembly Instructions - Page 2

Browse online or download pdf Assembly Instructions for Monitor displayit Graffiti:Plus Wall - Kit A. displayit Graffiti:Plus Wall - Kit A 5 pages. 10’ x 10’ inline display kit

Print Page
Endcap
Channel Bar
5. Snap four endcap channel bars onto
the sides of the frame.
Top Frame "X"
Light Bar
Light Bar
Bottom Frame "X"
Stitched edge
goes in first
Start in
the corner
13A. Install the back fabric reflector. Begin by tucking the corners and midway across the
top and bottom. The stitched edge of the silicone goes into the SEG channel first.
displayit.com
Adjustable Foot
6. Carefully stand the frame up with the
adjustable feet on the floor.
Note: This may require two people.
Coiled Wire
Wire To Top Light
Wire Split
Back
SEG
Channel
SEG
groove
Back of the Frame
800.207.0311
8. Snap a light bar onto the center of the "X"
located at the top of the frame.
9. Connect the coiled end of the wire to the
light bar.
10. Snap another light bar onto the center of the "X"
located at the bottom of the frame.
11A. Connect the male end of wire split to the light
bar.
11B. Connect the power supply to the female end of
the wire split. Plug in the power supply to test.
12. Repeat steps 8-11 to install a light bar onto each
"X" on the top and bottom of the frame.
Power Supply
Fabric
Re ector
After-Hours Emergency: Call or Text 678.723.5343
10' x 10' Inline Display Kit A
Assembly Instructions
7. If the frame is on an uneven
floor or if it leans, adjust the
bottom feet.
13B. Complete installation of the fabric.
Gra ti:Plus V.2 Updated 10/10/2019
Adjustable
Foot
2