displayit flare Assembly Instructions - Page 2

Browse online or download pdf Assembly Instructions for Digital Signage displayit flare. displayit flare 4 pages. Accessory kiosk with monitor mount
Also for displayit flare: Assembly Instructions (3 pages)

Print Page

Diagram 3

8. Loosly attach top piece to side pieces using 2

corner brackets. Connect the support pole to the

center channel of the top piece. Hand tighten all

wing nuts on corner connectors to secure. At this

point, the frame should look like Diagram 3.

DO NOT EXCEED 9 LONG LED BARS PER 200 WATT POWER SUPPLY

(190 WATT MAX.) EVENLY DISTRIBUTE LIGHTS ACROSS BOTH OUTPUT WIRES

Thumb Screw

Flat nut

9. Attach LED light bars to the frame using thumb screws and ﬂat nuts as seen in Diagram 4.

Two short bars may be subsituted for one long bar.

Try to limit spaces between light bars, to create an even glow on the graphic.

For double-sided displays, the support pole may need to be moved to make room for the lights.

11. Snap-on wire management clips help stop wire shadows.

displayit.com

8' Jumper Wire for Top Lights

displayit.com

800.207.0311

Assembly Instructions Page 2

Top Lights: 2 Long, 3 Short LED Bars

Short

Long

Short

Wire clip

Approximately 39" Apart

(Room for one short and one long light bar)

Long

Short

Bottom Lights: 2 Long, 3 Short LED Bars

POWER SUPPLY MAY BECOME HOT WITH CONTINUED USE

UNPLUG AND ALLOW TO COOL BEFORE TOUCHING

12. Feed the wires through the

ﬂexible grommet. Plug the

transformer into an AC outlet

to test the lights.

After-Hours Emergency: Call or Text 678.723.5343

8' (92" x 92") Flare

Long

Short

Long

Short

Male

Female

(Transformer Side)

(LED Side)

10. Wire the lights as seen in

Diagram 4.

Flare v1.8 Updated 3/1/2016