Aerial Airborne Wakeboard Tower Installation Manual - Page 11

Browse online or download pdf Installation Manual for Boating Equipment Aerial Airborne Wakeboard Tower. Aerial Airborne Wakeboard Tower 14 pages.

Print Page

STEP 11

STEP 2

STEP 12

make sure that there are no burrs on the inside of the

top section tubes.

someone will need to hold the top section for you as

you insert the front arms into the top section and con-

nect the hinge fittings into the side rails.

*** IMPORTANT NOTES ***

- Lubricate telescopic parts with a light grease before

sliding together.

- Grease will not prevent the smaller diameter tube from

being scratched by the top section tube during insertion

so be very careful not insert the side section tube any

further than the final installation width.

Do the same for the rear arms. It is important to try to

keep the top section centered on the boat during this

process.

Note: the top section can be rotated up or down to be

parallel with the boat.

BE CAREFUL! We CANNOT be liable for any burring or

scratching that may occur when sliding the tube in and

out of the top sections.

Drilling the top section.

the x measurement is a great way to make sure that

your tow point is in the center of your boat. to do this,

measure from the tow point to your rear foot, then to

your other foot. cover your boat with an old sheet or

old cover to make removing the metal shavings easy.

someone should hold the top section while you drill.

ImAGE shows thE

sIDE sEctIon bEInG

AttAchED to thE

sIDE rAIl.

GUIDE#: pwb-AIrbornE-v1-004