Camdata MeLock User Manual - Page 5

Browse online or download pdf User Manual for Computer Accessories Camdata MeLock. Camdata MeLock 8 pages.

Print Page

5.1 Calibration

The MeLock contains a feature to allow it to be re-calibrated to suit the situation in which

it is used. The default factory calibration should be suitable for most circumstances,

however if you feel that you have to move too far from the PC before it locks (or not far

enough) the calibration procedure is described below.

The MeLock must be paired with an activator before it can be calibrated.

Once paired (LED will be green) enter calibration mode by double tapping on the back of

the MeLock. The LED should now change to flashing green.

Wearing the activator, work normally (walking around if wanted) in the area where you

would like the MeLock to NOT lock the PC. After about 4 minutes the MeLock has

collected enough calibration data, so it stores the new values and returns to normal

mode. If communication with the activator fails during calibration then the MeLock

restores the factory default settings, and returns to normal operation. To cancel

calibration before it has finished, double tap the back.

To restore the factory settings double tap on the back of the MeLock while it is unpaired

(plug it in and double tap before it has had a chance to pair).

There is a red/green LED indicator on the MeLock USB stick.

When first plugged into the PC the LED will turn RED for about one second.

Otherwise the LED state is given in the following table:

In addition the LED will change from off to green (or on to off) when you

touch the capacitive switch on the back of the MeLock.

The un-pairing warning starts about 10 seconds before a normal un-pairing,

or about 20 seconds before a stationary un-pairing.

May 1 1, 2 011