Aeris swopper Series Instructions For Use Manual - Page 7

Browse online or download pdf Instructions For Use Manual for Indoor Furnishing Aeris swopper Series. Aeris swopper Series 20 pages.

Print Page

Technical Data

"swopper"
Spring
CLASSIC, STANDARD
SMALL
CLASSIC, STANDARD, CARE
MEDIUM
CLASSIC, STANDARD
STRONG
WORK
MEDIUM
SADDLE
SMALL
SADDLE
MEDIUM
SADDLE
STRONG
Base ring: without rollers dia. 55 cm, with rollers dia. 58 cm
Weight: "swopper" without backrest: 11 kg,
"swopper" with backrest: 17 kg
DYNAMIC backrest: height adjustable from 106 to 116 cm
How to assemble your "swopper"
Your "swopper" is delivered in three parts. Assemble the
"swopper" parts as shown in the figure.
Please note: disassembly is to be done only by an authorised
dealer (special tool required). Work on or replacement of
the gas spring must be carried out by a trained specialist only.
1
2
1 Insert the spring in the opening on the base ring.
2 The scale should point to the open side of the base ring.
3 Now place the seat on the spring strut.
Bounce up and down
12
Seat height
Seat height
Spring hardness
unloaded
loaded
optimised for
47 to 61 cm
42 to 56 cm
40 to 80 kg
52 to 65 cm
45 to 60 cm
60 to 120 kg
53 to 65 cm
47 to 63 cm
90 to 140 kg
50 to 62 cm
42 to 57 cm
60 to 120 kg
57 to 71 cm
52 to 66 cm
40 to 80 kg
62 to 75 cm
55 to 70 cm
60 to 120 kg
63 to 75 cm
57 to 73 cm
90 to 140 kg
3
– ready!
How to assemble the backrest
You can also use the "swopper" with a backrest. You
1–2
can mount a backrest easily at any time. An assembly
tool is provided with each backrest.
1 Tilt the "swopper" carefully in the direction of the
opening in the base ring.
2 Using the Allen key supplied, from below you press
out the plug in the base of the base ring.
3–4
3 Set the backrest rod on the base ring so that the
setscrew engages in the opening in the base.
The backrest base must sit firmly on the base ring.
4 Set the nut provided from below onto the setscrew
and screw tight using the spanner. The backrest rod
should have no play at all.
5 Put the "swopper" upright again. Fit the backrest
5–6
with the corresponding formed counterpart onto the
rubber bearing at the top end of the backrest rod.
6 Fasten the backrest to the rubber bearing from
the front using the screws supplied and screw tight.
That's it!
How to fit the cover for the
DYNAMIC backrest (accessory)
Pull the open cover over the backrest. Be very
careful to ensure that the Velcro® fastener does not
come into contact with the inside padding. Fasten
the Velcro® fastener and close the zip fastener.
That's it!
13
D
EN
FR
NL