3DGence DT3 Manual - Page 2

Browse online or download pdf Manual for 3D Printers 3DGence DT3. 3DGence DT3 14 pages.

Print Page

Rules for Safe Operation

Important: Do not attempt to operate the 3DGence DT3 until you have read

thoroughly and understand all instructions and safety rules contained in this

manual. Failure to comply may result in personal injury.

• As a normal industry safety practice, be sure the

machine has been plugged into a 230vac ground

fault interrupt outlet.

• Protective neoprene gloves, as well as protective

eye goggles, should be worn when cleaning parts

in the 3DGence DT3. Having a source of fresh

water nearby is helpful to wash off any solution

that splashes on exposed skin or parts. During

normal operation of the 3DGence DT3, the tank and

lid will become hot (up to 65C). Care should be

taken to avoid exposed skin touching these hot

surfaces causing a burn.

• Use stainless steel or plastic tongs to insert and

remove parts from the 3DGence DT3 tank. DO NOT

use aluminum tongs.

• Your 3DGence DT3 is equipped with a timer as a

safety measure only. The machine should never be

left unattended.

• When operating the 3DGence DT3, facing the

front provides an unobstructed view of the control

panel display, as well as direct access to the

power switch in case quick shutdown is necessa-

ry. All normal operations should be performed

facing the front, with the exception of accessing

the drain valve, which is located on the back of the

3DGence DT3.

3DGence DT3

• 3DGence DT3 weights approximately 30kg empty

and should never be moved when liquid is present

in the tank. Sections 9 and 10 of the Operations

guide detail how to properly drain and dispose of

used chemical solution prior to moving the 3DGen-

ce DT3.

• 3DGence DT3 is designed for indoor use only, at

room temperatures between 18C and 21C. 3DGen-

ce DT3 will not operate at a temperature at or

below 4C.

• 3DGence DT3 is designed for cleaning with VXL

EX. It is NOT designed for cleaning or heating food,

cosmetic or medical products, nor metal or

other non-water soluble plastic parts. Do not use

chemicals that are not pre-qualiﬁed by 3DGence,

this will result in voiding the warranty.

• 3DGence DT3 should not be used in an explosive

atmosphere. Normal internal sparking of the pump

motor could ignite fumes.

• 3DGence DT3 has a working dimension inside the

tank of 25.4cm by 28cm by 31cm. Be careful not to

insert too many parts (to be cleaned) so as to

overﬂow the level of the tank.

Jet action cleaning