Aeris SmartSense Debugging Manual

Browse online or download pdf Debugging Manual for Monitor Aeris SmartSense. Aeris SmartSense 4 pages.

Print Page

Aeris System Debugging Guide

August 2015

Aeris SmartSense ®

Debugging Guide

Part Number: 01-571-8301

Revision: 8/26/15

Rev: A

Instructions: To help us better understand the issue, before returning the parts for warranty, please check

with an "X" each box below and briefly explain the malfunction of the system on the blank space provided.

☐ Are all hoses connected together from the axle to the control box?

See setup section in

debugging guide.

☐ Did light blink 3 times in control box on power up?

See step 1 in debugging guide.

☐ Did light at front of trailer blink 3 times on power up?

See steps 2 & 3 in debugging guide.

☐ Is the light at the front blinking inconsistently after the 3 blinks?

See step 4 in debugging guide.

☐ Is the light at the front staying on or blinking consistently?

See step 5 in debugging guide.

☐Does the light eventually turn off?

See step 6 in debugging guide.

Setup

Connect the Driver Left Rear (Curbside rear) Axle Pressure line to the far left point on the flow manifold

closest to the regulator.

Connect the Driver Left Front (Curbside front) Axle Pressure line to the second position on the flow

manifold.

Connect the Driver Right Front (Roadside Front) Axle Pressure line to the third position on the flow manifold.

Connect the Driver Right Rear (Roadside Rear) Axle Pressure line to the far right point on the flow manifold

farthest from the regulator.

Note: On single axle systems the two middle ports should be plugged as the front axle will not be used.

Connect control box to ABS connector pigtail

Connect Driver Warning Light (DWL) to 7 way connector power and ground

Page 1 of 4