Divine Lighting Hyper 363P RGB User Manual - Page 11

Browse online or download pdf User Manual for Lighting Equipment Divine Lighting Hyper 363P RGB. Divine Lighting Hyper 363P RGB 18 pages. Led par lighting

Print Page

WWW.DIVINELIGHTING.COM

To use the built-in program (Pr- -)

 Press MENU, go back to the initial setting

 Press UP / DOWN until Pr- -

 Press ENTER to choose. The display will start blinking

 Press UP / DOWN to change the address code.

 Press ENTER to select and store the current menu options. DMX mode will be

stored automatically and the screen will stop blinking.

Pr00: red

Pr01: green

Pr02: blue

Pr03: amber

Pr04: cyan

Pr05: purple

Pr06: white

Pr07: red strobe

Note：Pr7--- Pr15 can change the content of SP，correct the speed of jumping change,

SP00 (fastest) to SP15 (slowest)

8. Operating Mode Instructions



Master/Slave

Master: Units are set to master mode by default. (i.e. outputting DMX signal that mirrors

their own DMX input) unless a DMX controller is used. Signal lines longer than 200 feet (60

meters) or 20 lamps should use a signal amplifier.

Slave: Connect all slave units to the master unit using a DMX cable. Set all slave units

to SLAU mode OR address them to the same channel (typically d001). Any adjustments

made to the master should be displayed on the slave units as well. To ensure proper

signaling, only one light should be set as Master. Use of a DMX controller will override the

signal output of a light that is using its own internal program (i.e. flash, fade)

Pr08: green strobe

Pr09: blue strobe

Pr10: amber strobe

Pr11: cyan strobe

Pr12: purple strobe

Pr13: white strobe

Pr14: three color (RGB) strobe

Pr15: seven color strobe