Camille Bauer KINAX N705-MEMS Operating Manual - Page 12

Browse online or download pdf Operating Manual for Transmitter Camille Bauer KINAX N705-MEMS. Camille Bauer KINAX N705-MEMS 12 pages. Canopen inclination transmitter
Also for Camille Bauer KINAX N705-MEMS: Operating Manual (13 pages)

Print Page

7. Programming instruction

Control panel:

The inclination transmitter is programmable via keypad. The keyboard

is visible after opening the blue cover.

Modus:

The transmitter remains in programming mode for 60 minutes. If no key

is pressed during this time, the transmitter will exit the programming

mode without storing the programmed data.

Standard programming I (programming start and end value)

Application:

The measuring range (e.g. 4 - 20 mA) is between two fixed

tilt angles (e.g. – 10° to + 60°). The final position can be pro-

grammed via keystroke after mounting the KINAX on the aligned

object. The instrument can be electrically connected in any position.

+60°

20 mA

1. Programming mode «on»

press quickly: 2x red (R; R; ...LED on)

2. Put transmitter into initial position (+60°; 4 mA)

programming 0%

press quickly: 1x left green (0%; ...LED flashes 1 s)

3. Put transmitter into final position (-10°; 20 mA)

programming 100%

press quickly: 1x right green (100%; ...LED flashes 1 s)

4. Switch sense of rotation (optional) (-10°; 4 mA)

press quickly: 1x red (R; ...LED flashes 1 s)

5. Programming mode «off»

press quickly: 2x red (R; R; ...LED flashes1 s, LED off)

PM 1002077 000 00

LED

green button

Red button

–10°

4 mA

Inclination transmitter KINAX N705-MEMS 4...20 mA

Standard programming II (Zero position programming)

Application:

The measuring range (e.g. 4 - 20 mA) is adjusted by factory and

symmetrically split (e.g. ± 45°). The range is calibrated on factory side

and should not be changed. The initial position can be programmed

via keystroke after mounting the KINAX on the aligned object. The

instrument can be electrically connected in any position. The adjusted

measuring range is symmetrical and starts from zero position, e.g. the

zero position corresponds always to 12 mA.

+45°

1. Programming mode «on»

press quickly: 2x red (R; R; ...LED on)

2. Programming zero position

press quickly: 1x green left & right (0% & 100%; ...LED flashes 1 s)

3. Switch sense of rotation (optional)

press quickly: 1x red (R; ...LED flashes 1 s)

4. Programming mode «off»

ress quickly: 2x red (R; R; ...LED flashes 1 s, LED off)

To restore the factory settings (RESET):

1. Programming mode «on»

press quickly: 2x red (R; R; ...LED on)

2. Keep red key pressed (> 3 s)

(R; ...LED flashes 1 s; LED off)

-45°

0°

Position of the

cable feeder

arbitrary

12/12