Alto-Shaam 700-RW Installation, Operation & Maintenance Manual - Page 6
Browse online or download pdf Installation, Operation & Maintenance Manual for Food Warmer Alto-Shaam 700-RW. Alto-Shaam 700-RW 19 pages. Hot food holding, round wells, electric with halo heat technology
Print Page
W A R N I N G
Improper installation, alteration,
adjustment, service, cleaning, or
maintenance could result in property
damage, severe injury, or death.
READ and UNDERSTAND the
installation, operating and
maintenance instructions thoroughly
before installing, servicing, or
operating this equipment.
WARNING
Appliance and accessories may be
heavy. To prevent serious injury, always
use a su icient number of trained and
experienced workers when moving or
leveling appliance and handling accessories.
The Alto-Shaam round well must be installed
in a location that will permit it to function for
its intended purpose and to allow adequate
clearance for ventilation, proper cleaning, and
maintenance access.
1. The round well must be installed on a stable and
level surface.
2. DO NOT install this round well in any area
where it may be affected by any adverse
conditions such as steam, grease, dripping
water, high temperatures, or any other severely
adverse conditions.
3. DO NOT store or use any flammable liquids or
allow flammable vapors in the vicinity of this
round well or any other appliance.
4. This round well must be kept free and clear of
any combustible materials.
5. Countertop material must withstand temperature
up to 200°F (93°C). Verify countertop material
temperature rating with manufacturer before
installing to ensure counter can withstand heat.
6. A stainless steel heat shield is recommended if
the area under the unit is used for storage.
7. Countertop manufacturer may have specific
requirements for installation not covered in this
manual. Consult countertop manufacturer for
specific installation requirements.
I N S T A L L A T I O N
MN-35890 (Rev. 3) 04/16 • Round Wells • 4
C A U T I O N
To prevent SEVERE PERSONAL
INJURY or PROPERTY DAMAGE:
ALWAYS use hand protection when
operating this appliance to avoid
burns. Metal parts of this equipment
become extremely hot when in
operation.
W A R N I N G
FOR YOUR SAFETY
DO NOT store or use gasoline or
other flammable vapors or liquids in
the vicinity of this or any other
appliance.
S I T E I NS T A L L A T I O N
8. Verify required clearance per table below, then
make round cutout in countertop in accordance
with the drawings on the following pages.
9. Apply a bead of food grade silicone on the top
surface of the countertop, around the perimeter
of the cutout.
10. Set the round well in the center of the cutout
so that the flange is flush with the top of the
countertop. Use the supplied clamps to help
keep the round well in place. Tighten finger
tight only. Wipe away excess silicone after
installation.
LEVELING
The heated well should be leveled before
the electrical supply is connected. Level the well
from side-to-side and front-to-back with the use of a
spirit level.
CLEARANCE REQUIREMENTS
bottom
sides
6" (152mm)
6" (152mm)