3DUpFitters Ender 5 Plus R1 Enclosure Kit Installation Manual - Page 17

Browse online or download pdf Installation Manual for 3D Printers 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 pages.

Print Page

Higher Temperature = Less Cold Air

Pro Tip: measure your current temperatures before attempting to make any changes.

We get support calls saying "my enclosure is too hot" or "too cold," but they didn't

measure the temperature. Without measurements, it's impossible to tell if a printing

problem is temperature-related or

11. Tips and Tricks

On some surfaces the enclosure can slide around a bit. In

those cases try using thin double sided tape on the corners to

hold it in place.

Another issue is the magnets in the door are strong. You can

either use two hands to open the door, one holding the

enclosure and another to open the door, or reduce the aﬀects

of the magnet by adding a piece of black electrical tape to the

side of the strike plate that contacts the magnet. You'll need

to adjust the location of the magnetic latch by loosening the

wood screws, moving the latch, and retightening.

not.