Camina Art Etage Instructions And Assembly Use - Page 6

Browse online or download pdf Instructions And Assembly Use for Wood stove Camina Art Etage. Camina Art Etage 12 pages.

Print Page

Assembly

Cutting a hole in a

masonry chimney

Chimney insert

Design

requirements

The stove and the chim-

ney must be arranged in a

way that ensures that they

cannot start a fire in adjoi-

ning fixtures or parts of

the building. The flue must

be installed in a manner

which permits chimney-

sweeping for the full flue

length, and with ready

access to cleaning doors.

Connection to an existing masonry chimney

The stove is approved for a rear connection to a chimney with a ½ brick con-

nection point which is approved for a 350

1. Measure where the hole is to be made in the chimney. Mark the hole and chisel it out

so that it is slightly larger than the diameter of the chimney insert, allowing sufficient space

to cement the insert in place, using mortar. Cement the insert into the hole.

The stove is normally supplied

for a top connection. If you

intend to employ a rear con-

nection, use the rear-connection

cover plate instead to replace

the insert on top of the stove.

Apply stove sealant to ensure

a good seal between the stove

and the cover plate.

When connecting the stove to a proprietary modular chimney, follow the manufacturer's

instructions.

Place the floor plate/fireplace base in position.

If you are going to connect the stove from the top into the masonry chimney,

the loose top stone unit should be placed in position before the flue pipe is

fitted.

Apply stove sealant to the stove insert and push the flue pipe into position. The stove is

then placed in position and the flue pipe is cemented in place. If you are using a chimney

insert, tamp in packing fibre around the flue pipe. Check that the distances are correct.

Design specifications

Colour

Glass, ceramic

Door

Grate

Hearth base

Hearth lining

The hearth is approved for a chimney with a ½ brick connection (350

the stove is designed for a chimney draught of at least 12 pa, as provided by a

chimney with a minimum length of 3.5 metres and a cross-section of 150-200

(diam. 150 mm).

Output

Nominal output

Efficiency (SS-EN 13240)

Weights:

Camina Art Suprême

Camina Art Grace

Camina Art Étage

Camina Art Moderne

Camina Art Pierre

Flue-pipe diameter

Product-type and environmental approval

CE-approval

Optional extras

Outdoor air connection

Fan

Soapstone base (only for Grace/Etage)

Cast iron base (only for Grace/Etage)

Floor protection, straight or curved

C flue-gas temperature.

Fit the connection pipe which

is to be fitted into the chimney

insert over the stove connection

insert. Apply a thin layer of

stove sealant around the insert

before fitting the connection

pipe.

Senotherm

Withstands 700

Sheet steel

Cast iron

Vermiculite

Diam. 60 mm

240 V

15 kg

Toughened glass

Grey sheet metal

As an alternative to a straight

rear connection, you can use

a top/rear connection to a

masonry chimney. In this case,

the angle must have an inspec-

tion door to permit cleaning.

C), and

2-8 kW

5.5 kW

70%

122 kg

124 kg

210 kg

190 kg

150 mm

39 53 03

0402