esera automation 19200 Linux Manual - Page 2
Browse online or download pdf Manual for Recording Equipment esera automation 19200 Linux. esera automation 19200 Linux 9 pages.
Print Page
4
Commissioning
Please start with the commissioning of ESERA-Station 200 with the 1-Wire Gateway. To do so, connect to the
Config Tool 3 via USB cable, which you can download from our website.
Here you can find the Config Tool 3:
controller-1-wire-gateway/
Important:
Please start updating the time and date when
commissioning the 1-Wire Gateway.
For more details on commissioning, please refer to
the "How To" videos on our website, here:
https://www.esera.de/service-support/how-to-
support-videos/
5
VNC Access
You can access the ESERA-Station directly via VNC. The thinghtvnc is pre-installed on the ESERA-Station.
For access via PC, we recommend the free UltraVNC.
Here you can find the Ultra VNC Software:
You can find installation instruction here:
6
Access data
The following are the access data for accessing the Linux operating system
User:
pi
Password:
esera
SSH Acces
User:
pi
Password:
eserassh
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
https://www.esera.de/produkte/software/downloads-firmware-1-wire-
http://www.uvnc.com/home.html
http://www.uvnc.com/install/installation.html
19200 V1.0 R1.0 Commissioning II
Access data:
To connect tot he ESERA-Station, enter the
IP-Adress and „:1"
(IP-Adress:1)
Password: eseravnc
The resolution is fixed at 1280x800 by default.
After you have logged in, please assign a new
own password..
New password for VNC access:
Start the LX Terminal and enter the
command:
vncpasswd
Page 2 of 9