3DUpFitters Prusa i3 MK3 Installation Manual - Page 7

Browse online or download pdf Installation Manual for 3D Printers 3DUpFitters Prusa i3 MK3. 3DUpFitters Prusa i3 MK3 18 pages. Enclosure kit
Also for 3DUpFitters Prusa i3 MK3: Installation Manual (11 pages)

Print Page

View from Outside the Front

The front door is designed so that the latch is on the left.

Attach the corner connectors on the inside of the door

frame using the provided cap head 12mm screws. The

top of the connector should be ﬂush with the top of the

acrylic. Adjust the screws snugly, but not tight as you'll

adjust them later.

There is also a mid-panel corner connector to attach on the

right side. Use a 12mm M4 screws.

Locate the magnetic latches and use the wood screws to

attach them to the latch mounts. Hand tighten and make

sure they're secure, but do not over tighten or they may

strip. The magnetic latch can be later adjusted front-to-

back to make sure the door is ﬂush with the door frame.

Each latch mount is attached via three screws. Two M4

12mm cap heads are used to attach the latch mount to

the side, while a 30mm cap head secures the latch mount to the door frame.

Attach the hinges to the outside of the door and door frame using M4 12mm screws

and nuts. There will be some play in the hole size so that you can adjust the door to

swing freely.

Attach the door knob by ﬁrst inserting the square M4 nut

into the slot. Use a 16mm cap head screw to attach the

door.