ClearCube Cloud Desktop CD9500 series Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Desktop ClearCube Cloud Desktop CD9500 series. ClearCube Cloud Desktop CD9500 series 8 pages.

Print Page

Default

settings and IP

address

(continued)

Setting up zero

clients

ClearCube Technology, Inc.

Cloud Desktop CD9500/7500

By default, zero clients and host cards are configured to receive an IP

address from a DHCP server. If a DHCP server does not assign an

address within 120 seconds, the zero client uses a default, fallback IP

address. Fallback addresses enable devices to always have a known IP

address. See PCoIP System User's Guide for more information.

NOTE:

If you use the fallback addresses and have DHCP enabled,

you must wait 120 seconds before you can connect to a

host. If you use the direct connect methodology in your

environment, ClearCube recommends disabling the

client's DHCP setting to eliminate the need to wait 120

seconds before connecting. See PCoIP System User's

Guide for more information.

The steps below show how to connect peripherals, a network cable,

and a power supply to a zero client. These steps assume that the zero

client and host card are on the same network as a DHCP server.

Step

Power on the remote PC blade containing the host card

to which you are going to connect.

Connect a monitor cable to each port on the zero client

and to your monitors. See

monitors"

below

Connect a network cable to the connector located on the

rear of the zero client, and then connect the other end of

the cable to the appropriate network infrastructure device

(such as a network switch, fiber transceiver, or router).

Connect a USB keyboard and a mouse to the USB ports

on the front or on the rear of the zero client.

Connect the power cable to the AC power adapter (both

are included with the zero client).

www.clearcube.com

Action

"Single and high-resolution

for alternate video configurations.

Continued on next page

(866) 652-3500

5 of 8