3DUpFitters Taz6 Enclosure Kit Installation Manual - Page 11

Browse online or download pdf Installation Manual for 3D Printers 3DUpFitters Taz6 Enclosure Kit. 3DUpFitters Taz6 Enclosure Kit 15 pages.

Print Page

The large 60mm hole is either for the included fan by

itself, an air ﬁlter (purchased separately)/fan combo,

or it can be covered up by a plastic disk depending

on how much airﬂow you want.

Conﬁrm the fan's direction by plugging it into a USB

power supply before attaching the ﬁlter. The round

label should be on the outside.

The fan should be attached to the outside of the

enclosure.

The fan should be oriented to pull air OUT of the

enclosure.

Use the long screws included in the fan packet to attach the fan. The length of the

screws may change depending on the depth of this particular shipment of fans.

Refer to the Air Filter directions if you purchased the optional air ﬁlter.

6. Attach Right Side