3DUpFitters Prusa i3 MK3S Installation Manual - Page 9

Browse online or download pdf Installation Manual for Enclosure 3DUpFitters Prusa i3 MK3S. 3DUpFitters Prusa i3 MK3S 18 pages. Enclosure kit
Also for 3DUpFitters Prusa i3 MK3S: Installation Manual (11 pages)

Print Page

3. Assemble Back

The four corner connectors are mirror images

of the front.

On each side are "mid panel corner

connectors", which are basically simple L-

shapes for added strength.

The large 60mm hole is either for the included fan by itself, an air ﬁlter (purchased

separately)/fan combo, or it can be covered up by a plastic disk depending on how

much air ﬂow you want.

Note that the fan, either by itself or paired with a

ﬁlter or vent is necessary to draw air over the power

supply. This both heats up the air inside the

enclosure AND cools down the power supply,

which extends its life. Only use the circular disk

(not included) to cover up the hole if you have

moved the power supply outside of the enclosure,

or if you simply don't care about power supply

longevity.

Conﬁrm the direction of the fan's air ﬁlter by

plugging it into a USB power supply before attaching to the ﬁlter and back of the

enclosure. The fan should be oriented to pull air OUT of the enclosure. Use the

long screws included in the fan packet to attach the fan. The length of the screws may

change depending on the depth of this particular

shipment of fans.

The U-shaped hole is for the cable grommet and

holder. This will allow you to remove the enclosure

without having to unplug the cables!