3E THERMOSALD ISC Quick Start Manual - Page 9

Browse online or download pdf Quick Start Manual for Controller 3E THERMOSALD ISC. 3E THERMOSALD ISC 20 pages. Temperature controller for impulse sealing. modular system

Print Page

STURT UP

4.1 - STURT UP PROCEDURES – INSPECTING THE SYSTEM AND THE PARTS USED

Stage 1 – In order to properly set up the system, read the instructions given in paragraph 4.8 THEORETIC

CALCULATIONS AND DIAGNOSTIC PROCEDURES and 4.9 SETUP PROCEDURES WITH THE AID OF

THE MULTI-LINGUAL CONTROL PANEL

Stage 2 – Use a Low Voltage Unit for power transformer outputs up to 10 Volt

Use a Standard Unit power transformer outputs from 11 to 99 V.

Use a High Voltage Unit for power transformer outputs from 100 to 140 V.

Use Primary mode for pulsed currents more than 220Amps.

Stage 3 – Make the system contructed in an workmanshiplike manner.

Stage 3.1 – Use sealing bands supplied by our Company or equivalent (don't use NI-CR sealing bands).

Stage 3.2 – The power cable inside the T.A. must not turn around T.A (only 1 single line inside).

Stage 4 – For any further information, call 3E – ENGINEERING DEPARTMENT.

TECHNICAL NOTES

From software V5.1 it's possible modify the temperature coefficient of the sealing bands in part per milion PPM; modifying

the PPM also other parameters will change in automatic as shown in the following table; for compatibility with the previous

models the thermoregulator outputs from our factory with the default temperature coefficient PPM=1465 that maintain the

heating characteristic and the voltage of the analog input unchanged.

TABLE OF PARAMETERS DEPENDING ON TEMPERATURE COEFFICIENT

PPM=

BIT/°C=

T.MAX[°C]=

IN. ANALOG.[ mv/°C] 4V/300=13.33 4V/384=10.42 4V/454=8.81 4V/500=8.00

POT.(°C/GIRO)

NOTE: 488, 1000, 4V, 10 are constants

THERMOSALD ISC – MANUAL QUICK START

Manual cod.: 3ES080x_V5.1_QS_EN

Includes all previous models

Master Reset

1465

1300

1465:488=3

1300:488=2.6 1100:488=2.2 1000:488=2.0 913:488=1.8 750:488=1.5

300

1000:2.6=384 1000:2.2=454 1000:2.0=500 1000:1.8=555 1000:1.5=666

300/10=30

384/10=38.4

1100

1000

454/10=45.4

500/10=50

Page Nr.

913

750

4V/555=7.21 4V/666=6.00

555/10=55.5

666/10=66.6

Rev. 2010 / 03

Tot. Nr . 20