Alto-Shaam Hot Carving Shelf 100-HSL/BCS-2 Installation, Operation & Maintenance Manual - Page 6
Browse online or download pdf Installation, Operation & Maintenance Manual for Food Warmer Alto-Shaam Hot Carving Shelf 100-HSL/BCS-2. Alto-Shaam Hot Carving Shelf 100-HSL/BCS-2 19 pages. Hot carving shelf, electric
Also for Alto-Shaam Hot Carving Shelf 100-HSL/BCS-2: Specification Sheet (2 pages), Installation And Operation Manual (20 pages), Installation, Operation And Maintenance Manual (16 pages)
Print Page
E L E C T R I C A L C O N N E C T I O N
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
1. An identification tag is permanently mounted
on the unit.
2. If necessary, a proper receptacle or permanent
wiring for this unit must be installed by a
licensed electrician in accordance with
applicable local electrical codes.
3. Plug the unit into a properly grounded
receptacle ONLY, positioning the unit so the
power supply cord is easily accessible in case
of an emergency. Arcing will occur when
connecting or disconnecting the unit unless
all controls are in the OFF position.
I N S T A L L A T I O N
/
VOLTAGE
PHASE CYCLE
HZ
AMPS
125
1
50/60
230
1
50/60
#802/ 1 Op eratio n & Care Manual •
230V:
To prevent an electrical shock hazard between
the appliance and other appliances or metal
parts in close vicinity, an equalization-bonding
stud is provided. An equalization bonding lead
must be connected to this stud and the other
appliances / metal parts to provide sufficient
protection against potential difference. The
terminal is marked with the following symbol.
NOTE: The appliance must be connected to an
electrical circuit that is protected by an
external GFCI outlet.
ELECTRICAL
kW
8.0
1.0
5-15
NEMA
P
15A 125
V PLUG
7/7
CEE
4.5
1.0
220-233V
PLUG
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code
ANSI/NFPA No. 70.
electrical connections are to be made
in accordance with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
5.
In Canada, all