ESI AA100 Installation And Use - Page 2

Browse online or download pdf Installation And Use for Racks & Stands ESI AA100. ESI AA100 4 pages. Articulating keyboard arm

Print Page
AA100 ARTICULATING KEYBOARD ARM
PLEASE REVIEW these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
PARTS PROVIDED
Articulating Arm (1)
Front Stop (1)
Rear Bumper* (1)
*
Optional
ADDITIONAL TOOLS REQUIRED
Drill with
/
" bit
•
1
8
STEP 1: Drill Pilot Holes for Attaching Track
• Position one end of the track
edge of the work surface.
• Drill
/
" pilot holes through the seven h
1
8
indicated in the illustration.
— Drill the holes
CAUTION: Be careful not to
drill through the top of the work
surface.
With this short 13" track, the track
extender is normally used as the rear
stop. If the rear bumper will be used
instead, drill a pilot hole is the center
rear hole and do not drill pilot holes
in the two rear side holes.
2
Track Extender (1)
CAUTION: This install requires a power drill.
This is not a hand tool install
#2 Phillips drill bit
•
/
" from the front
1
2
/
" deep.
5
8
Track (1)
Cord Clip (1)
oles
/
" Wood
5
8
Screws (20*)
*
Includes Extras
Underside of
Work Surface
/
"
1
2
Drill
/
" Pilot Holes
1
8
Where Indicated