Alto-Shaam CS-100 Manual - Page 8
Browse online or download pdf Manual for Commercial Food Equipment Alto-Shaam CS-100. Alto-Shaam CS-100 20 pages. Carving station
Also for Alto-Shaam CS-100: Installation, Operation And Maintanance (20 pages)
Print Page
e L e c t r i c A L c O N N e c t i O N
d A N G e r
ELECTRICAL CONNECTIONS MUST
BE MADE BY A QUALIFIED SERVICE
TECHNICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES.
d A N G e r
ENSURE POWER SOURCE
MATCHES VOLTAGE IDENTIFIED
ON APPLIANCE RATING TAG.
1. An identification tag is permanently mounted
on the carving station.
2. If necessary, a proper receptacle or outlet
configuration as required for this unit, must be
installed by a licensed electrician in accordance
with applicable, local electrical codes.
3. Plug carving station into a properly grounded
receptacle ONLY, positioning the unit so the
power supply cord is easily accessible in case
of an emergency. Arcing will occur when
connecting or disconnecting the unit unless all
controls are in the "OFF" position.
d A N G e r
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
carving stations
AltoShaam-webshop.nl
i N s t A L L A t i O N
NOte:
for CE approved units: To prevent an electrical
shock hazard between the appliance and other
appliances or metal parts in close vicinity, an
equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances / metal parts
to provide sufficient protection against potential
difference. The terminal is marked
with the following symbol.
e Lec tric A L - c s - 100
voltage
120
230
e Lec tric A L - c s - 200
voltage
120
230
•
/
/
installation
operation
service manual
d A N G e r
To avoid electrical shock, this
appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence of
local codes, with the current edition
of the National Electrical Code ANSI/
NFPA No. 70. In Canada, all electrical
connections are to be made in
accordance with CSA C22.1, Canadian
Electrical Code Part 1 or local codes.
Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
/
phase
cycle
hz
amps
1
60
4.2
1
50/60
2.2
/
phase
cycle
hz
amps
1
60
6.3
1
50/60
3.3
Wire.diagrams.are.located.on.the.bottom.outside.of.the.unit .
(11/12) -
pg
kW
&
cord
plug
.50
NEMA 5-15P
15A - 125V Plug
.50
7/7,
cee
220-230V
plug
kW
&
cord
plug
.75
NEMA 5-15P
15A - 125V Plug
.75
7/7,
cee
220-230V
plug
. 6
AltoShaam-webshop.nl