ESI FLEX2-SLV Instructions Manual - Page 8

Browse online or download pdf Instructions Manual for Indoor Furnishing ESI FLEX2-SLV. ESI FLEX2-SLV 12 pages. Electric table base

Print Page

ALL-FLEX

ELECTRIC TABLE BASE

™

STEP 16

"Zero set" the system before testing operation. (Note that with the table and keypad upside-down, the

UP s and DOWN t buttons face their opposite directions.)

• Press and hold the UP s and DOWN t buttons at

the same time. Continue to hold the buttons. The

legs will lower until they reach their bottom point.

• Release the buttons once the system beeps. If it

does not beep, continue to hold the buttons for

3 seconds after the legs reach the lowest point. The

system is now "zero set."

• Press the UP s and DOWN t buttons to test operation. End your test with the legs lowered and unplug the

power cord.

• If there are problems with operation, check that all cable and cord connections are secure. If problems

continue, call ESI Customer Service.

STEP 17

Use the pre-installed cable clips plus the additional ones provided to secure the cables in position.

• Cables must not interfere with table operation.

• Cables must not interfere with the user.

Press and Hold Both Buttons

Digital Keypad

Work Surface

Cable Clip

ASSEMBLY