ClearMirror BigSexy 16105-306024M Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Indoor Furnishing ClearMirror BigSexy 16105-306024M. ClearMirror BigSexy 16105-306024M 7 pages. Showerlite led back-lit, fog-free shower mirrors

Print Page

WARNING: Mirror must be caulked or grouted into the tile or surround complete and flush with

tile surface. Back edge of the mirror cannot be exposed to touch. Failure to do so could result in

electric shock or injury.

FINISHING THE MIRROR

1. Caulk or grout around the edges.

IMPORTANT (SAVE THESE INSTRUCTIONS)

When using electrical appliances, basic precautions should always be followed to

reduce the risk of fire, electric shock, and injury to persons, including the following:

Read all instructions before installing or using this heater.

• Do not operate any heater after it malfunctions. Disconnect power at service panel and

have heater inspected by a reputable electrician before reusing.

• Do not use outdoors.

• To disconnect heater, turn bath switch to off, and turn off power to heater circuit at main

disconnect panel (or operate internal disconnect switch if provided).

• Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this

may cause an electric shock or fire or damage the heater.

• To prevent a possible fire, do not block air intakes or exhaust in any manner.

• Use this heater only as described in this manual. Any other use not recommended by the

manufacturer may cause fire, electric shock, or injury to persons.

OPERATING INSTRUCTIONS

• The ClearMirror assembly must be properly installed before it is used.

• The ClearMirror is to be installed flush with the tile with wiring fed from behind the full, wall-

mounted assembly.

• Be certain that the controls are operational per the instructions in that the bathroom light,

ceiling fan or alternate switch power on and power off the ClearMirror.

• Do not modify the installation from within (or outside) the assembly, and do not tamper with

any user-operated devices intended to reduce the risk of fire, electric shock, or injury to

persons; and warn against tampering with such devices.

• Any servicing should only be done by a qualified service person.

Figure 4. Grout around the mirror to seal and finish.