ESi Ergo VICTORY 2VT-C36-30 Series Instructions Manual - Page 5

Browse online or download pdf Instructions Manual for Indoor Furnishing ESi Ergo VICTORY 2VT-C36-30 Series. ESi Ergo VICTORY 2VT-C36-30 Series 8 pages. 2 leg electric table base

Print Page

ASSEMBLY

STEP 11

Make connections to the control unit and motors.

• Connect the cable from the digital keypad.

• Connect the motor cables to the control unit and

to each of the motors on the table legs.

• Connect the power cord to the control unit.

• Plug the power cord into an AC outlet.

CAUTION: Do not operate the table until after "zero

setting" the system. See following step.

STEP 12

"Zero set" the system before testing operation.

• Press DOWN t to lower the legs to their lowest

position. (Note that with the table upside-down,

the DOWN arrow faces up).

• Press DOWN t again for about five seconds.

The legs will move further down slightly to their

absolute lowest position. Release the DOWN t

button.

• Press the UP s and DOWN t buttons to test

operation. End your test with the legs lowered

and unplug the power cord.

• If there are problems with operation, check that

all cable and cord connections are secure. If

problems continue, call ESI Customer Service.

STEP 13

Use the cable clamps and ties to secure the cables

in position.

• Cables must not interfere with table operation.

• Cables must not interfere with the user.

STEP 14

With the assistance of a helper, turn the table

upright and place it in its final position.

IMPORTANT: There must be 1" (25mm) of clearance

on all sides of the work surface (and other moving

parts) to ensure free, unobstructed movement.

• Adjust the leveling glides on the feet to level the

work surface, if necessary.

• Plug the power cord into an AC outlet.

• See the following pages for operating

procedures.

VICTORY 2 LEG ELECTRIC TABLE BASE

Keypad

Cable

Motor

Cables

DOWN

Button

Power

Cable

Cable Management