Alto-Shaam HALO HEAT 200-HST/G Installation Operation & Maintenance - Page 6

Browse online or download pdf Installation Operation & Maintenance for Merchandiser Alto-Shaam HALO HEAT 200-HST/G. Alto-Shaam HALO HEAT 200-HST/G 15 pages. Hot food shelf with granite insert
Also for Alto-Shaam HALO HEAT 200-HST/G: Specification Sheet (2 pages)

Print Page

E L E C T R I C A L C O N N E C T I O N

ELECTRICAL CONNECTIONS MUST

BE MADE BY A QUALIFIED SERVICE

TECHNICIAN IN ACCORDANCE WITH

APPLICABLE ELECTRICAL CODES.

1. An identification tag is permanently mounted on

the unit.

2. If necessary, a proper receptacle or permanent

wiring for this unit must be installed by a

licensed electrician in accordance with applicable

local electrical codes.

3. Plug the unit into a properly grounded receptacle

ONLY, positioning the unit so the power supply

cord is easily accessible in case of an emergency.

Arcing will occur when connecting or

disconnecting the unit unless all controls are in

the OFF position.

I N S TA L L AT I O N

ELECTRICAL

VOLTAGE

PHASE

CYCLE

125

# 8 1 4 I N S TA L L AT I O N / O P E R AT I O N / S E RV I C E M A N U A L • 5.

IMPROPER INSTALLATION, ALTERATION,

ADJUSTMENT, SERVICE OR MAINTENANCE

COULD RESULT IN SEVERE INJURY, DEATH

OR CAUSE PROPERTY DAMAGE.

AMPS

11.7

1.5

To avoid electrical shock, this

appliance MUST be adequately

grounded in accordance with local

electrical codes or, in the absence of

local codes, with the current edition

of the National Electrical Code

ANSI/NFPA No. 70.

In Canada, all

electrical connections are to be made

in accordance with CSA C22.1,

Canadian Electrical Code Part 1 or

local codes.

BARE END

NO PLUG