ABC Office foil1200 Operating Instructions

Browse online or download pdf Operating Instructions for Foiling machine ABC Office foil1200. ABC Office foil1200 2 pages. Foil fuser / roll foiling machine

Print Page

Foil Fuser / Roll Foiling Machine

Turn machine and roller on using the HEAT and RUN switches located on the right side of the

machine (above power cord).

Adjust the temperature on the HEAT knob located on the right side of the machine on

approximately 285ºF. The actual temperature will be reflected on the LCD read-out on top of the

machine. Note – Do not be concerned if the temperature fluctuates some both before and during

foiling, as this is normal.

Warning – Do not set temperature above 350ºF.

Load foil roll onto the front feed roller bar. Pull out knob located on the left side of machine to

release roller bar. Pull roller bar out. Slide a roll of foil onto the roller and replace roller bar. Pull

approximately 8 inches of foil from roller and feed through unit using a piece of card stock as a

guide until the foil comes through the back of the unit. Make sure foil is fed under the bard below

each roller, front and back.

Slide an empty foil core on the rear take-up roller and tape foil to core with white or uncolored

side facing up.

"When You Need More Than Staples."

Toll Free: 800-658-8788

Fax: 801-927-3037

[email protected]

Operating Instructions