Aimpoint CompM5b User Manual - Page 16

Browse online or download pdf User Manual for Magnifiers Aimpoint CompM5b. Aimpoint CompM5b 20 pages.

Print Page

Create a custom elevation setting

a Set the custom turret and custom turret ring to a desired setting.

NOTE: The serrations on the custom turret ring fits the indicator on the locking tab to

produce "clicks". Each custom turret ring clicks corresponds to a 20 mm movement

of Point of Impact (POI) at 100 m. Turning the turret counterclockwise results in

moving POI up. Similarly, turning the turret clockwise moves POI down.

b Insert the drill tool into the drill tool guide as shown in Fig. 7.

CAUTION: DO NOT USE the drill tool without the drill tool guide. Using the drill tool

without the guide can cause irreversible damage to the custom turret and the sight.

c Firmly hold the custom turret while turning the drill tool to create a mark ("A" / Fig. 7).

d Remove the drill tool and inspect the mark. The mark shall be similar to the reference

mark on the drill tool ("B" / Fig. 7).

e Repeat the steps c to d to create more marks in the custom turret.

f Remove the drill tool and the drill tool guide.

g Remove the custom turret ring. Do not remove the custom turret.

h Reinstall the spring lock to the sight and tighten with the T10 Aimpoint tool or

alternatively use the hex key socket on the drill tool guide ("B" / Fig. 6).

CAUTION: DO NOT create overlapping marks ("B" / Fig 7). Ensure the custom

turret is turned at least 3 custom turret ring clicks between each setting.

NOTE: The custom turret ring offers 60 clicks of adjustment from the chosen Zero

Range. At very long distances from the Zero Range, the amount of adjustment

needed to accurately hit a target may become too large. Chose a greater Zero

Range in order to extend the effective range up to the desired distance.