Aimpoint Gaim Compact A Step By Step Manual - Page 2

Browse online or download pdf A Step By Step Manual for Virtual Reality Headsets Aimpoint Gaim Compact. Aimpoint Gaim Compact 11 pages.

Print Page

ENGLISH

Set up an Oculus account and connect your headset

1. Download the Oculus App on your phone.

2. Connect the Oculus App to a Facebook account.

3. Connect your headset to the Oculus app.

In the Oculus app on your phone go to: Devices // Pair New Headset // select Quest

Quest 2 // follow the instructions in the app and headset

Download the GAIM app

1. Open the camera on your phone and hold it over the QR code

to the right to be sent to the download page, or visit the website

at bit.ly/downloadgaim

2. Press "Get" and the GAIM app will be added to your library in

your headset. You will find the GAIM App after a few minutes

under apps in your headset.

3. You can also search for GAIM in your Oculus app on the phone.

Click "Show app" under App Lab. Then click on GAIM to download.

Enter license key

1. Inside headset, start the GAIM App.

2. Enter your license key exactly as written in your confirmation

e-mail ( e.g . X1X5X-7XXX9-XX4X3).

3. Press "play".

4. In some cases, you need to go back to license key input and press "play" again.

If the license key is not accepted:

1. Try to reload game.

2. Try to re start headset.

3. If this does not work contact [email protected].

English

ENGLISH

Bluetooth pairing: trigger – headset

Before you start pairing the GAIM controller, make sure that...

1. the headset and smartphone are connected to the same WiFi.

2. the headset is cleared from all previous bluetooth connections.

In your headset, go to settings // experimental features //

bluetooth pairing // select pair and in the menu, delete any previously

connected devices.

3. the trigger unit is in pairing mode.

Put the battery in the trigger unit. Press and hold the trigger for at least

30 seconds or until the slow blinking starts. The led light on the side of the

trigger unit should start to show a slow blinking pattern. If the blinking

stops, press the trigger once to turn on the blinking again. (The led light is

only visible when the trigger unit is not attached to the controller.)

Start pairing

1. Turn on the headset and open the Oculus app on your smartphone.

2. In the Oculus app on your phone, click on devices and select your headset. It

should say "Connected" in the top left corner.

3. Click on Controllers.

4. Click on Pair New Controller.

5. Put the trigger unit in pairing mode by putting in the battery and then hold the

trigger down for at least 30s to get a calm , blinking light on the side of the trigger.

6. Click on "Pair Gamepad".

7. Select GAIM Controller from the list. It may take a moment before it appears in the list.

8. You will receive an error message this can be ignored. The trigger is connected!

Open the camera on your phone and

hold it over the QR code for videoguide:

English