ClearSpan 108986 Manual - Page 8

Browse online or download pdf Manual for Greenhouse Kit ClearSpan 108986. ClearSpan 108986 17 pages. End frame kit 36' wide x 16' 2" high

Print Page

CLEARSPAN

END WALL FRAMING KITS

™

END PANEL INSTALLATION (CONTINUED)

4. Once the end panel is temporarily secured, take the roll

of 1" strapping and weave the end of the strap through

the D-rings and around the rafter pipe as shown below.

Strap with built

in D-rings near

the top edge of

the end panel.

Main security strap woven

through D-rings and around

the end rafter.

Photo above shows a building with the main cover

already installed. View is from the inside looking up at

the rafter and main cover. Rafter design may differ from

actual rafter.

NOTE: Maintain an even space between the rafter

and the top of the end panel. The end panel flap that

extends beyond the D-rings is tucked between the

rafter and the main cover.

DO NOT attach the flap to the end rafter at this time.

5. Stretch the bottom of the end panel evenly out on the

ground along the bottom frame tube of the end wall

frame (if needed) and tighten the 1" strap at the top of

the end panel. Top of end panel must remain as close

to the rafter as possible.

NOTE: Verify that the lower end of the panel remains

on the ground as the top is tightened. If the panel

begins to lift off the ground, loosen the top evenly along

the radius of the rafter. (In a later step, the end panel

is stretched from the bottom to pull the panel tight and

into position using the end panel horizontal conduit,

straps, and ratchets.)

6. With the top edge of the end panel secured, continue

by installing the end panel conduit.

Main Cover

End Panel

Space below is reserved for customer notes.

Revision date: 11.12.14