ClearSpan Cedar 8' Wide End Frame Kit Manual - Page 9

Browse online or download pdf Manual for Greenhouse Kit ClearSpan Cedar 8' Wide End Frame Kit. ClearSpan Cedar 8' Wide End Frame Kit 9 pages.

Print Page
4
INSTALL FILM END PANELS
Gather the parts:
•
End panel film
•
Poly latch U-channel (#102197)
•
Spring for U-channel (#102198)
•
Tek screws (#FA4482)
View the diagrams to install the poly latch U-channel and
attach the end panel film.
1. Using Tek screws, attach sections of the poly latch
U-channel along the outside of the frame base as
shown in the diagrams.
NOTE: If main cover is installed, detach the main cover
from the end rafter. Reinstall main cover after end film
has been installed.
2. Unfold and position the end film over the end rafter. Drape some of the material over the top rafter leaving enough
to reach the ground plus 6" - 12". Center the film so equal excess material is on each side of the shelter. Tape can
be used to temporarily hold material in place if needed.
3. Once end film is in position, attach the film to the end rafter starting at the top of the end rafter. If U-channel is
present, work your way down each side and wiggle the wire spring back and forth to seat the spring into the
previously installed U-channel. Holding the film in place and pull it tight while working down the end rafter.
4. Install the remaining springs into the
U-channel attached along the frame base.
Pull the cover snug while installing the
spring.
DO NOT REMOVE TOO MUCH OF THE
EXCESS FILM MATERIAL. Some excess
end film material–the material that extends
beyond the U-channel–should remain
in place. If the film needs stretched in
the future, remove the spring from the
U-channel, grasp the excess material, pull
the film tight, and reinstall the spring.
CAUTION: Risk of Injury
Always wear eye protection when
installing the 102198 spring!
Step 1
102197
FA4482B
Space Tek screws evenly about 24" apart.
Revision date: 05.18.10
End panel installed. View as seen from outside the building.
Drawing may show a different but similar model.
Step 1
Step 4
Ground Level
View as seen from outside the building.
CLEARSPAN
END FRAME KIT
™
9