ClearSpan CL108552 Manual - Page 18
Browse online or download pdf Manual for Greenhouse Kit ClearSpan CL108552. ClearSpan CL108552 19 pages. 42' x 104' economy building
Print PageCLEARSPAN
FABRIC STRUCTURES
™
INSTALL PVC CONDUIT (CONTINUED)
3.
Repeat the steps and continue to assemble and feed the PVC conduit into
the pocket.
4.
Once the PVC conduit is fully assembled, secured at the joints, and inserted
into the pocket, repeat the steps for the remaining end of the main cover.
5.
With both PVC conduits installed, verify that the cover is centered on the
frame (side-to-side and end-to-end) and move to one end rafter.
6.
Take rope or strap and cut a few sections long enough to tie the PVC
conduit to the end rafter in a few evenly spaced locations. See example in
the photo below.
Main Cover
Bonnet
End Rafter
Temporary
strap or rope
7.
Move to the end of the frame opposite the end where the temporary straps
were tied, take one end of the bulk roll of 1" strapping, and weave it around
the end rafter and PVC conduit.
18
Photo shows temporary
PVC conduit in
straps tied between the
notched pocket
PVC conduit and the end
rafter to keep the main
cover centered on the
frame as the strapping at
the other end of the frame
is installed.
Cover used for illustration
only. Actual cover may
differ from what is shown.
8.
Continue weaving the strap around the end rafter and PVC conduit working
up and over the rafter and down to the other end of the PVC conduit.
NOTE: Keep the strapping snug during this step, but do not over tighten.
Also, maintain a even distance between the end rafter and the PVC conduit.
Photo shows how to weave strap around the conduit inside
the main cover pocket and the end rafter. (Cover and rafter
shown differ from actual cover.) Distance between the
conduit in the pocket and the end rafter is even.
9.
After weaving the strapping, cut the strap and tie it to the end rafter to
temporarily secure it.
10.
Take the remainder of the bulk strap roll, move to the other end of the
frame, and repeat the steps to weave the strap between the PVC conduit
and the top of the end rafter.
NOTE: The temporary rope or straps at this end can be removed once the
main strapping is in place.
11.
After the strap is completely installed at this end, cut the strap to length and
tie it to the end rafter.
Revision date: 09.08.09