ClearSpan Pro Solar Star R035B00009B Manual - Page 10
Browse online or download pdf Manual for Greenhouse Kit ClearSpan Pro Solar Star R035B00009B. ClearSpan Pro Solar Star R035B00009B 13 pages. Greenhouse door kits
SINGLE CORRUGATED DOOR ASSEMBLY (continued)
6.
Install sections of the horizontal closure strips
(104709) under the panel before attaching the panel
to the door frame. Trim closure strips as needed.
7.
Drive Tek screws and washers through the panel,
closure strip, and into the frame every 6" or so. Install
Tek screws and washers in the valleys of the panel.
Screws should be snug. Do not overtighten screws.
Latching
Door Latch
8.
Attach the panel in the locations as shown to hold
Plate
Guide
the panel in place. If needed, secure the sides of
the polycarbonate panel to the door frame using Tek
screws only every 16".
9.
Attach the
door latch guide to the door frame using
the remaining 1/4" bolts. Trim the edge of the
corrugated panel as needed to allow free movement
of latch.
Horizontal
10.
With assistance, set the assembled door in the end
Position
wall door frame and secure hinges to the door jamb
using one Tek screw per hinge at this time.
NOTE: Verify that there is sufficient clearance along
all door edges to allow the door to swing freely in
the opening. If end panels are installed, loosen the
panels, secure the hinges directly to the door jamb,
and reinstall panel fasteners.
11.
Test the door operation, adjust hinges as needed, and
install the remaining Tek screws to secure hinges.
12.
Mount latching plate to door jamb frame using Tek
screws. The screws supplied with the latch are not
used for metal jambs. Trim end panels if needed.
13.
After attaching the door to the frame, read the care
and maintenance section.
Closure Strip
STEP 6
10
Corrugated Single Swinging Door
Valley
Tek Screw
and Washer
Closure Strip
104709 strip
STEP 9
Latching
Door Latch
Plate
Guide
Horizontal
Position
STEP 12
Trim corrugated panel as needed
to install the door latch guide.
STEP 7
STEP 8
Closure Strip
Closure Strip
STEP 11
Revision date: 05.28.10