AIMS PWRINV2.5K24V Assembly And Operating Instructions Manual - Page 8

Browse online or download pdf Assembly And Operating Instructions Manual for Inverter AIMS PWRINV2.5K24V. AIMS PWRINV2.5K24V 9 pages. 2500 watt / 5000 watt peak input voltage 24 volts dc

Print Page

If the low battery alarm sounds, this means that the input voltage is below the

necessary 21 V. The battery needs recharging. You should stop using the

appliance and then recharge the battery. If this is not done, the Inverter will

shut off automatically at around 20 V.

If you are unsure if the inverter will have the proper amount of current to run

the device, use this rough guideline: Take the power consumption of the load

in watts and divide it by 24 (input voltage). The result will be the approximate

number of amps needed to power your device.

Example: Load is rated at 312 watts. 312 watts / 24 V = 13 amps needed. You

could use this device with the inverter.

If your television will not start, it is important to keep in mind that some appliances

(including many televisions) may require two to six times their wattage to start

up.

If your audio system buzzes while using this inverter, it is because some sound

systems can not filter out the modified sine wave produced by the inverter.

Use a sound system that incorporates a higher quality power supply.

This inverter is made to minimize the interference with TV signals. However,

especially with weak TV signals, some interference may still be visible. To

correct this, place the inverter as far away as possible from the television

antenna and it's cables. Next, adjust the orientation of the inverter to the antenna

cables and TV power cord to minimize the interference. Also use a shielded

antenna cable.

If the low battery alarm is on all the time, try these corrective measures:

Recharge battery if in poor condition. Next, check the battery connection. You

may need to clean the connectors.

If you are getting a low output voltage, try reducing the load to minimize watts.

You may have overloaded the inverter. Reduce your load to 2400 watts. Also,

keep input voltage above 21 volts to maintain a constant flow of power.

If you are not getting any power output, turn the power switch Off and On

again, until the green power light comes on. Your devices may draw too much

power to operate them. The inverter may be in thermal shutdown. Let it cool

down and make sure there is adequate ventilation around the unit.

If the green light turns red one of the following has happened:

A. Input voltage is too low. B. input voltage too high C. Short circuit D. Inverter

is near overload.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN

THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR

MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS

QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO

REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR

EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN

BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL

RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR

REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACE-

MENT PARTS THERETO.

AIMS PWRINV2.5K24V Assembly And Operating Instructions Manual - Page 8

Troubleshooting Tips