ClearView PowerBoards PB-DG-001 Installation & User Manual - Page 8

Browse online or download pdf Installation & User Manual for Automobile Accessories ClearView PowerBoards PB-DG-001. ClearView PowerBoards PB-DG-001 9 pages. For ram 1500 pick-up truck 2015-2018

Print Page

Installing control unit and wiring

Position Motor Wiring (XS-W01A) for Actuator Motors RH & LH

1. RH Motor Cable to be run across under the Dash Panel, over the Transmission Tunnel and positioned

under Steering Column.

2. Negative wire to be run to the left and earthed to the body.

3. LH Motor Cable, should already be positioned on the LH Side.

Route Motor Wiring from Actuator Motors into Vehicle

4. Unwind Wiring Looms labelled for RH Motor and LH Motor.

5. Locate existing rubber grommets in floor panel of vehicle, adjacent to the RH & LH Motors.

6. Remove grommets and cut a single hole in each grommet, sized to allow the plug on the wiring looms to

pass through.

7. Replace grommets back into floor panel of vehicle and feed end of the Wiring Looms with small plug

through the hole in the grommet.

8. Route both of the Wiring Looms (RH & LH) as shown above. This will require the removal of the Sill Trim

and the Cowl Trim

9. Connect the motor wires plugs to the corresponding Actuator Motor Plugs and the ECU Plugs

Route Power Wiring from Engine Compartment into Vehicle

10. Route Power Wiring from Battery in Engine Compartment as shown, then feed the white plug through

the LH rubber grommet where the LH Motor Wiring enters the vehicle.

11. Route Power Wiring Loom as shown above.

12. Connect the Power Wiring Plug to the corresponding ECU Plug and to the Vehicle Battery inside the

Engine Compartment

Page | 8

Due to Clearview Continuous Improvement Program, information may change without notice.

Clearview takes no responsibility for the result of incorrect use of these installation instructions.

PB-TA-001

PB-DG-001

April 2018