ClearView PowerBoards PB-NN-003 Installation Manual - Page 9

Browse online or download pdf Installation Manual for Automobile Accessories ClearView PowerBoards PB-NN-003. ClearView PowerBoards PB-NN-003 15 pages. For nissan patrol y62 2013

Print Page

Fitting Instructions

Step 4

Connecting Power to the motor brackets

4.1 Connect motor wires to corresponding

connectors on motor wire harness.

Passenger side wires are

and Driver side wires are

Route the RM (Right Middle) driver-side

motor wire under the vehicle dash and

bring across to the driver-side cabin, then

route through the factory grommet and

vehicle floor, then connect wire to the

motor connector on the RM (Right

Middle) Bracket Assembly.

Route the LM (Left Middle) passenger-

side motor wire through the factory

grommet and vehicle floor, then connect

the wire to the motor connector on the

LM (Left Middle) Bracket Assembly.

NB: Holes for routing can be found under the

floor carpet. (For both LM & RM motor wires)

4.2 Re-insert fuse into positive wire and test motor by

opening and closing vehicle doors, or by using the door

switch button.

4.3 Tidy up all electrical wires and cable tie wires to the

chassis where possible to minimise risks of wires getting

caught on objects.

You may also apply electrical tape/heat shrink/conduit

to wiring and connectors to provide additional

protection.

4.4 Mount control unit in the Passenger side upper kick

panel area, OR where available should there be limited

space or other accessories in the way etc.

NB: The control unit should not be placed in the vehicle

engine bay, as exposure to heat and moisture may cause

damage to the unit.

green

/ yellow,

red

/ blue.

clearviewaccessories.com.au

Passenger side (left)

motor wiring

Driver side (right)

motor wiring

*For illustrative purposes only

Mount control unit in upper kick

panel area, OR where available

*For illustrative purposes only

Connector for LM Motor

Connector for RM Motor