ClearView HD4112 User Manual - Page 14

Browse online or download pdf User Manual for Modulator ClearView HD4112. ClearView HD4112 14 pages. Quad hdmi mpeg2 hd dvbt encoder modulator

Print Page

7. System Setting

Press Setup then Setup System

You can reset the unit to Factory Default or just Hardware Reset by clicking on this

dropdown here. Be sure to always press the Save Settings to the left after selecting your

option. The IP Address of the unit can be adjusted in the 192.168 range. The last 2 sections

are adjustable here.

You can save the Modulator Config by pressing This Button.

It can be re-loaded by Choosing the File then uploading it into the Modulator.

After all settings have been adjusted always press the-

Store Settings and Reboot System for them to be saved completely.

When using more than one unit in an installation, use the RACK POSITION feature

To set parameters differently in each modulator in the rack so they do not interfere with

each other. The values can be overridden and saves in the SETUO RF and TS menus if you

have other units in the system with same parameters. Press Rack Position SAVE SETTINGS

to save rack position. It will take a little time to re-boot and save.

If the buttons turn grey while you are adjusting settings, Log out then back in again

To activate them.

The

STATUS

but only shows you status of the device and changes cannot be made in this

menu.