EdgeWave IPRISM 75G Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Gateway EdgeWave IPRISM 75G. EdgeWave IPRISM 75G 4 pages. Secure web gateway

Print Page
iPrism Secure Web Gateway
Quick Start Guide
2.2
Go to your workstation, and point your browser to the IP address that you just gave iPrism, using port 80 (it will
redirect to the https port).
Step 3. Run the Installation Wizard
To complete the Installation Wizard you will need the setup data from Step 1 and your iPrism License Key file (should be
saved to your desktop). The following is an outline of the Installation Wizard steps:
3.1
Username and Password
The Wizard will prompt you for a user name and password. The defaults are Username: iprism; Password:
3.2
Agree to License
You will be prompted to accept the License Agreement. Read the agreement and click
3.3
New or Restore Config
New Customers should select
Existing customers can restore their settings from their backup by selecting
uploading their archive. Once that is completed the iPrism will shut down.
3.4
Upload License Key
Browse to the location where you saved your iPrism License Key file, then click
3.5
Enter Registration Information
Enter your contact information. Choose carefully as your Administrator email is used for delivering important iPrism
product update information. It is recommended that you change your password by selecting
3.6
Network Settings
Enter the setup data you recorded in Step 1. To enter the IP address for your DNS, click
Name Servers pop-up window. Enter your DNS address and click
Step 1.5. Select
OK
Note:
Some of the values on this page are pre-populated, they can be changed.
3.7
Filter Settings
Specify whether to monitor and/or block Web and application traffic, and select the iPrism time zone.
3.8
Review Settings
Review the configuration settings and click Apply. To make changes to any of the settings, click Back.
Note:
You can only use the
3.9
iPrism will save and apply the settings and reboot automatically – this may take 4-5 minutes.
Your iPrism Installation is Now Complete
Step 4. Shut Down and Relocate the iPrism Appliance
Ensure proper shut down and relocate the iPrism to a network or subnet that will be convenient for testing, typically near
your Internet gateway. Connect a network cable between your switch and the INTERNAL iPrism interface, and turn on the
power.
Start a new configuration
then
Next
to continue.
Print
option with a local printer. Configuration reports will be available once you reboot.
and click
Next
to continue.
Proceed to Step 4
Next
OK
to continue. Enter your IP address recorded in
(If it is not already located in a production setting)
setup
Agree
to continue
Restore from archive
and then
to continue.
Set
Password.
DNS Settings
then
Add
V8.x
in the