ArtFox ATMIC 3000 User Manual - Page 5

Browse online or download pdf User Manual for Spotlight ArtFox ATMIC 3000. ArtFox ATMIC 3000 7 pages.

Print Page

·Finally, the signal line connected to the output jack of a strobe light into a signal the best

terminator. Signal termination is a public signal line Caron, 2 feet and 3 feet in a 1/4W120

European resistance welding, the control signal so that it will not absorb reflection and cause

interference.

DMX Control

DMX mode control functions from the DIP DIP switch selection

DMX Mode 1 allows strobe from the controller adjust the speed from 0 times / sec to

maximum speed, and production came to light effects, select DMX mode 1 is a function of

the DIP switch 5 set to ON, the rest of the DIP switch 1-4 off. Case diagram as follows:

DMX mode 2 is to control the brightness strobe, strobe duration and speed, compared to

more advanced mode of the first channel. DMX mode 2 is selected function DIP switch DIP

switch 1-5 off. Case diagram as follows:

DMX mode 3 is the brightness of the strobe, strobe duration and increased the rate of 6

special effects. Select DMX mode 3 is 1,2,3,5 DIP switch off function will turn on DIP switch

4 (set ON). Case diagram as follows:

Set the address code of light

Lamps on the rear panel has a 10-bit DIP switch, which is to select the address code 1-9 use,

Address code can be 1-511 arbitrary choice。

Establish DMX address code

1 Select an address controller installed in the lamp. DIP switch address code query the table

below;

2 The DIP switch 1 to 9

(1) Open on or off

(0) listed in the table below, turn off the DIP switch 10。

Found on the address code in the table. Read the DIP switch settings on the left of 1-5 and 6-9

above, the DIP switch address code. "0" means off and "1" means open. DMX operation code