AIMS Power PWRIC150012W Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Inverter AIMS Power PWRIC150012W. AIMS Power PWRIC150012W 10 pages. Dc to ac power inverter

Print Page

overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to

maintain a constant flow of power.

•

If you are not getting any power output, turn the power switch Off and On again, until the

green power light comes on. Your devices may draw too much power to operate them. The

inverter may be in thermal shutdown. Let it cool down and make sure there is adequate

ventilation around the unit.

•

If the green light turns red one of the following has happened:

A. input voltage is too low

B. input voltage is too high

C. short circuit

D. inverter is close to overload

•

Battery voltage is too low: Start the engine to recharge the battery. Replace or recharge

battery if needed.

•

Shuts down on overload: Reduce the wattage of your load.

•

Thermal shutdown: Under heavy loads for extended period, the inverter will shut

down to prevent damage from excess heat. Simply reduce your load and allow the

Inverter to cool down.

•

Low-battery shutdown: Recharge your battery and resume operation.

MAINTENANCE

Very little maintenance is required to keep your inverter operating properly. You

should disconnect input power first and then clean the exterior of the unit

periodically with a dry cloth to prevent accumulation of dust and dirt. At the same

time, tighten the screws on the DC input terminals.

Neither the manufacturer nor distributor makes any representation or warranty of any kind to the

buyer that he or she is qualified to make any repairs to the product or that he or she is qualified to

replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all

repairs and parts replacements should be undertaken by certified and licensed technicians and not by

the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original

product or replacement parts thereto, or arising out of his or her installation of replacement parts

thereto.