FiTech 51004 Quick Start Manual

Browse online or download pdf Quick Start Manual for Medical Equipment FiTech 51004. FiTech 51004 2 pages.

Print Page

Kit Contents

(51001) 20ft. Stainless Braided Hose

(51002) 20ft. Black Braided Hose

(51003) 40ft. Stainless Braided Hose

(51004) 40ft. Black Braided Hose

(1) 10 Micron Fuel Filter

(2) ORB-8 to AN-6 Filter Fitting

(1) Check Valve

(6) AN-6 Straight Hose End

(3) AN-6 45° Hose End

(3) AN-6 90° Hose End

(1) Hose End Assembly Tape

When determining hose routing never

make sharp turns that can put stress

on the hose and could cause kinks.

Make sure all hose lengths have at

least a little slack and that the hose is

not twisted. This will ensure there is

no stress on the hose which will

extend the life of the hose.

Fuel Line Kit # 51001,

51002, 51003, 51004

Mark the desired length of hose by

wrapping the hose with provided tape. Using a

fine-tooth hack saw, cut-off wheel, or cable

cutters, cut through the tape and hose. NOTE: A

clean perpendicular cut is important to ensuring

proper installation.

Hold or clamp the socket side of fitting into

a soft jaw vise. Insert hose into socket and push

while turning clockwise until hose is snug against

the socket's threads. TIP: mark hose at the

socket with tape or marker to easily see if hose

backs out when threading fittings together.

Clamp nipple side of fitting into soft jaw

vise. Apply lube to nipple. Thread socket onto

nipple threads by hand as far as possible. Then

using a wrench, thread socket onto the nipple

end until the socket base is within 1/16th inch or

less of a gap between socket base and the nipple

hex.