dji PHANTOM Quick Start Manual - Page 8

Browse online or download pdf Quick Start Manual for Drones dji PHANTOM. dji PHANTOM 17 pages. Led indicator description & faq
Also for dji PHANTOM: Quick Start Manual (14 pages), Quick Start Manual (8 pages), Advance Manual (6 pages), Quick Start Manual (3 pages), Manual (6 pages), Quick Start Manual (3 pages), Mounting (2 pages)

Print Page

1. Aircraft & Transmitter Basic Operation

Aircraft & Transmitter Basic Operation

Definitions

 Stick neutral position and stick released means the stick of Transmitter is pushed to the central position.

 Command Stick means the stick of Transmitter is pushed away from the central position.

Transmitter

（

GPS ATTI. ATTI. ATTI.

OFF

You can change the operation mode of the Transmitter according to the advanced manual if necessary.

Aircraft

is the nose direction）

(

Manual or

Failsafe is

selectable

in software.)

Course Lock Home Lock

GPS ATTI. Mode/ATTI. Mode

Throttle stick is for aircraft up& down control. The aircraft will hold

the height automatically if the stick is centered. You should Push

the throttle stick to the neutral position to take-off the multi-rotor.

Note that the stick returns to the central position when released

for the transmitter V3.5. For the version below 3.5, the stick

cannot hold the central position when released.

Yaw stick is for aircraft rudder control.

Command stick controls the angular velocity of the aircraft, with

the maximum rudder angular velocity of 200°/s. Left stick

command gives counter clock-wise rotation of the aircraft, & vice

versa.

Roll stick is for aircraft left/right control and Pitch stick is for

front/back control. Command stick controls the angle of the

aircraft. Stick neutral position is for 0˚, its endpoint is 35˚. The roll

and pitch sticks return to the central position when released.

In GPS Mode, the aircraft will hover (hold horizontal position)



when sticks released.

In ATTI. Mode, the aircraft will keep attitude stabilizing without



horizontal position (different from hover in GPS Mode).

3-position switch (S1) on the Transmitter for mode control. Only

after Compass Module connection and Compass calibration, GPS

ATTI. Mode is available. Otherwise, all switch positions are for

ATTI. Mode. Pay attention because the GPS ATTI. Mode is

dependent on the number of GPS satellites acquired by the main

controller. Refer to the LED Indicator. When GPS signal has been

lost for 3s, system enters ATTI. Mode automatically. You can

enable the Manual Mode or FailSafe (also known as One-key

Go-home) in the assistant software->Basic->R/C->Control Mode.

3-position switch (S2) on the Transmitter for Intelligent

Orientation Control (IOC). Set the switch to OFF in basic flight.

This function is defaulted to off. If you want to use this function

refer to the advanced manual, and enable it in the assistant

software. Use IOC when you are familiar with basic flight.

8 |