EDIFIER W360BT Operating Instructions Manual - Page 6

Browse online or download pdf Operating Instructions Manual for Headphone EDIFIER W360BT. EDIFIER W360BT 10 pages. Wearable bluetooth earbuds

Print Page

5. Play music

Function

Increase volume

Decrease volume

Previous track

Next track

Pause play

Restore play

Section 6

6. Restore factory settings

Under Bluetooth searching status (red/blue light quickly flashes alternatively), press and hold the volume increasing

key

and volume decreasing key

headphone paired before, after successful clear with it, turn on the headphone, it will automatically enter into

pairing status.

■ Maintenance

● Do not place the product at the damp places so as not to affect the product's internal circuit.

● Do not place the product at the places exposed to sun or in high temperature. High temperature would shorten the

service life of electronic components, damage battery and make some plastic components deformed.

● Do not place the product at very cold places to prevent damaging the internal circuit board.

● Do not try to dismantle the product. If non-professional personnel operates, they may damage the product.

● Do not fall, vibrate strongly, strike the product with hard object to prevent damaging the internal circuit.

● Please do not use drastic chemical products and cleaner to clean the headphones.

● Do not use sharp objects to scratch on the product surface to prevent damaging the outer case and affecting

looking.

If the product cannot work properly, please send it to your qualified repair units, the personnel shall help you solve

your problem with their whole heart.

■ FAQs

1. The red light flashes instead of the blue light.

Answer: It means that the headphones battery is low. You need to recharge your headphones again.

2. The red light is off during charging.

Answer: a. Please ensure the charging device is properly connected with the headphones.

b. When the headphones are not used for a long time, the battery will enter the hibernate status. Now it

Headphone status

Play music

Pause play

at the same time and wait for 5 seconds, it will clear the device list that

Operation

Press volume increasing key

Press volume decreasing key

Press and hold volume decreasing

key

Press and hold volume increasing key

Press the multi-function key