dji Zenmuse H3-3D User Manual - Page 14

Browse online or download pdf User Manual for Drones dji Zenmuse H3-3D. dji Zenmuse H3-3D 18 pages.

Print Page

ZENMUSE H3-3D User Manual

Firmware & Software Upgrade

Firmware Upgrade

Follow the procedures below to upgrade the H3-3D's firmware. Failure to follow these instructions

carefully may damage the gimbal.

1. Ensure your computer has access to the internet.

2. Close all other applications (including anti-virus programs or firewalls) before upgrading the

firmware.

3. Make sure the power supply is securely connected. DO NOT unplug the power supply before

the upgrade is complete.

4. Connect the GCU to your PC through a Micro-USB cable. DO NOT disconnect the cable until

the firmware upgrade is complete.

5. Launch the PC Assistant and wait until the connection is established.

6. Select "Upgrade"

7. The DJI server will check the current firmware version.

8. If a newer firmware is detected, the PC Assistant will download and upgrade the firmware

automatically.

9. Wait until the upgrade completes.

10. Click "OK" and power cycle (turn off, then turn on again) the system to finish the upgrade

process.

CMU stands for "Camera Multi Unit", which is the management module for the camera.

To eliminate interference from the main controller, DJI recommends you disconnect the

CAN-Bus cable between the GCU and main controller before you upgrade the firmware.

Double check your set parameters once you have finished upgrading the firmware.

Repeat the above steps if the DJI server is experiencing heavy traffic or the firmware

upgrade fails.

Software Upgrade

Click Info

Software Info. If the latest version is newer than your current version, please upgrade

your software.

Obtain your gimbal's serial number (SN) by clicking the "Info"

32 digit authorization code that is used to activate the gimbal. This number is set at the time of

manufacture, before shipment. You may be prompted to fill in a new SN if you purchase a new

feature. If you fill an invalid SN more than 30 times, the gimbal will be locked and you will have to

contact our customer support to unlock the gimbal.

Main Control, IMU and CMU.

"SN". The serial number is a