dji Inspire 1 Quick Start Manual - Page 4

Browse online or download pdf Quick Start Manual for Quadcopters dji Inspire 1. dji Inspire 1 10 pages.
Also for dji Inspire 1: Quick Start Manual (11 pages), User Manual (20 pages)

Print Page

Fly Safe

DJI encourages you to enjoy flying in a safe, responsible and smart way.

DO NOT FLY

near or above people, near

trees, power lines or buildings.

DO NOT FLY

in rain, snow, fog, and wind

speeds exceeding 22 mph or 10 m/s.

Be very careful when flying 14,700 feet (4,500 meters) or more above sea level as the battery and aircraft performance may be reduced.

●

The Inspire 1's compass and GPS will not work in Polar Regions. The aircraft will auto switch to ATTI Mode and use the VPS for positioning.

●

Calibrating the Compass:

●

Make sure to calibrate the compass in every new flight location. The compass is very sensitive to electromagnetic interference,

which can cause abnormal compass data leading to poor flight performance or even failure. Regular calibration is required for

optimum performance.

DO NOT calibrate your compass where there is a chance of strong magnetic interference, such as magnetite, parking

●

structures, and steel reinforcements underground.

DO NOT carry ferromagnetic materials with you during calibration such as keys or cellular phones.

●

DO NOT calibrate beside massive metal objects.

●

If it is blinking red and yellow alternately after placing the aircraft on the ground, the compass has detected magnetic

●

interference. Change your location.

P Mode:

●

In this mode, the Inspire 1 has a strong GPS signal and can use the

VPS allowing it to hover accurately in position indoors and out. If

outdoors, this mode also means that a Home Point has been

locked so that it can Return to Home if the control signal is lost.

If you are not in this mode, toggle the Flight Mode

Switch to P position to enable it.

The Flight Mode Switch is locked in P mode by default.

Refer to the User Manual on how to unlock the switch.

There are three states in P mode.

P-GPS: GPS works best when outdoors in a wide open area, and

your Inspire 1 uses GPS to hover in place when the GPS signal is

strong. P-OPTI: If GPS is not available, the aircraft can use the

VPS to hover accurately. P-ATTI: Neither GPS or VPS available,

aircraft is using only its barometer for positioning, so only altitude

is controlled. Note that the VPS may not work properly when the

Inspire 1 is flying over water, over surfaces without a clear pattern,

or in a low light environment.

While returning home, its altitude can be adjusted by the user to avoid obstructions. Tall buildings may affect the remote controller signal. The

●

Failsafe Return to Home procedure will be triggered if the signal is lost. Be sure fly higher than any nearby buildings to avoid crashing.

400 ft

Always

fly under

DO MONITOR YOUR ALTITUDE

and fly under 400 feet

(120 meters).

DO MAINTAIN LINE OF SIGHT

and avoid flying behind buildings

or obstacles that block your view.

Return to home

It is important to understand basic

flight guidelines, for the safety of

both you and those around you.

Refer to the Safety Guidelines and

Disclaimer for more information.

More information at:

http://flysafe.dji.com/no-fly

GPS Positioning

Return to Home:

●

When the GPS signal is strong, the aircraft will be

able to record a Home Point and return to the Home

Point when needed. The GPS location is recorded

when the GPS signal icon in the DJI GO app is either

yellow or green.

The aircraft will return to the Home Point automatically in

the following cases (all require a strong GPS signal).

Smart RTH: When you press the RTH button on the

remote controller or in the App. Low Battery RTH: The

DJI GO app notifies users to take action when the

battery level falls to a specified threshold.

Failsafe RTH: When the remote controller signal is lost.

No Fly Zones

Vision Positioning

Altitude 3 m