dji DT7 User Manual - Page 3

Browse online or download pdf User Manual for Remote Control dji DT7. dji DT7 5 pages. 2.4g rc system
Also for dji DT7: User Manual (7 pages)

Print Page

Using the DT7 Remote Controller

Turn On the Remote Controller

The remote controller includes a rechargeable LiPo battery with a capacity of 2000 mAh.

1. Toggle the Power Switch to the right to power on the remote controller.

2. If the Power LED Indicator is solid green, the remote controller is functioning normally.

3. You can monitor the current battery level using the Battery Level Indicators on the front

panel of the remote controller as shown below.

Turn Off the Remote Controller

Push the Power Switch to the left to power off. The Power LED Indicator will go out and the

remote controller will be turned off.

Charging the Remote Controller

Charge the remote controller's battery by using the included micro-USB cable. The Power

LED Indicator will display a solid red light when charging is in progress. The Power LED

Indicator will display a solid green light when the battery is fully charged.

Left Dial

Turn the dial to the right, and the camera will shift to point upwards. Turn the dial to the left,

and the camera will shift to point downwards. The camera will keep its current position if the

dial is static.

Throttle Lock

Pull down the throttle stick to descend. The stick will lock into place and the aircraft will

descend steadily. Push the throttle stick upward to release throttle lock.

Trainer Port

The trainer port outputs the remote controller signal. There are three functions:

(1) Connect the remote controller to DJI Lightbridge via the trainer port. Refer to the DJI

Lightbridge User Manual for more details.

(2) Connect the remote controller to a simulator with PPM input.

(3) Master and slave remote controllers function is available. Note that only DJI A2 flight

control system (firmware version 2.5 or above) can support the function (3) now.

Master and Slave Remote Controllers

Using two remote controllers and a single receiver, the remote controllers work as Master

and Slave for aircraft and gimbal control. Only the DJI supplied remote controller's firmware

version 1.0.2.26 or above is compatible. Follow the steps below to set the two remote

controllers as Master/Slave:

(1) Link one remote controller to the flight control system, which will be the Master.

(2) Plug one head of the trainer port cable into the other remote controller, which will be the Slave.

(3) Turn the left dial on the Master controller to the left and hold, then plug the other head of

the trainer port cable into the Master controller.

(4) The Master remote controller will emit a beeping sound if the connection is successful.

Now you can release the dial.

Battery Level Indicators

25％

50％

75％ 100％

100%