Aimsak ALC 3540 Manual - Page 2

Browse online or download pdf Manual for Battery Charger Aimsak ALC 3540. Aimsak ALC 3540 3 pages.

Print Page

- Do not expose power tools to rain or wet conditions.

Water entering a power tool will increse the risk of electric shock.

- Do not abuse the cord. Never use the cord for carrying, pulling or

unpluging the power tool.

Keep cord away from heatm oil, sharp edges or moving parts.

Damaged or entangled cords increse the risk of electric shock.

- When operating power tools in outdoor, use an extension cord suitable

for outdoor use.

Use of a cord suitable for outdoor reduces the risk of electric shock.

- If operating a power tool in a damp location is unavoidable,

use a residual current device (RCD) protected supply.

Use of an RCD reduces the risk of electric shock.

2. Li-ion BATTERY CHARGER INSTRUCTIONS

WARNING! USE THE CORRENT VOLTAGE OF CHARGER.

- Do not charge other manufacturer batteries only except Aimsak's one.

The appliance is only suitable for charging Aimsak batteries.

Due to risk of fire and explosion.

- Ensure that the plug and power code is abnormalities.

Do not use damaged charger. Due to electric shock.

- Ensure the switch is in the off position before inserting battery pack.

Inserting the battery pack into power tools that have the switch on invites

accidents.

- Keep the battery charger in a dry and frost-free place.

Enter water in the battery charger create failure and electric shock.

- Do not carry the battery charger with power code and not to plug out with

the wire.

Protect from heat, water and sharp edge. Due to risk of short-circuit.

- Plug out immediately if battery charger is damaged or heated, due to fire

and explosion when charging continously.

- Ensure that charger terminal is clean. Pollution causes electric shock.

- Do not charge and operate the battery charger on combustible ground or

surroundings due to its

heating during the charging process. Heated battery charger currents to fire.