Custom Crimp CC4-50 Operator's Manual - Page 11

Browse online or download pdf Operator's Manual for Industrial Equipment Custom Crimp CC4-50. Custom Crimp CC4-50 17 pages.

Print Page

TROUBLESHOOTING

PROBLEM: CRIMPER WILL NOT RUN AT ALL

Check the E-Stop switch to be certain that it is not depressed. A slight twist is

required to release switch after it has been depressed.

PLC (Programmable Logic Control) must be reset.

PROBLEM: CRIMPER RUNS BUT IS SLOW OR NON-FUNCTIONAL

Check supply voltage to see that it matches the voltage specified on the tag

attached to the crimper.

Check motor rotation and be certain that the motor rotates in the direction of the

arrow on the motor housing. For three phase units rotation can be reversed by

switching any two wires in the plug.

PROBLEM: CRIMPER WILL CLOSE ON FITTING BUT DOES NOT DEVELOP

POWER TO COMPLETE THE CRIMP

Fitting is to large for selected crimp die. Select a crimp die that is closer to final

crimp diameter. Machine has built-in safety by-pass to protect internal components

from damage due to incorrect die selection.

Check oil level. Position dies to the fully open position and check oil sight gage in

rear of machine. Be sure the oil level is in the middle of the sight glass. Use ISO

32 or 46 weight hydraulic oil.

If problem(s) persist contact Customer Service for additional troubleshooting assistance

Page