artisan TORO 4000 Series Instruction And Spare Parts Manual - Page 5

Browse online or download pdf Instruction And Spare Parts Manual for Sewing Machine artisan TORO 4000 Series. artisan TORO 4000 Series 16 pages. Extra heavy duty cylinder bed lockstitch compound needle feed walking foot stitching machines

Print Page
artisan TORO 4000 Series Instruction And Spare Parts Manual
8. BOBBIN WINDER AND THREAD GUIDE COMPONENTS
28.
3.
4.
1.
Turn the handwheel counter-clockwise until the needle reaches
its lowest position.
2.
Place your open left hand under the Shuttle area to catch the bobbin.
5.
SWITCH OFF THE MOTOR BEFORE REMOVING
OR INSERTING A NEEDLE
Artisan recommends that you use only "SCHMETZ" brand Needles.
For Leather use size; 794 D, 794 S, 794 LR
For Canvas, Nylon and Fabrics use size: 794
1.
Turn the hand wheel counter-clockwise and raise the needle bar
to its highest position.
#
2.
Loosen the needle set screw
(1) remove the old needle and
insert a new needle #2 into the needle bar. Push it up into
the hole as far as it will go.
#
3.
Remember to locate the needle scarf
(A) towards the hand
wheel and the long groove of the needle to the left side.
#
4.
Securely tighten the needle set screw
(1).
3.
Depressing the retaining latch #(1) will open the bobbin case.
4.
Remove the bobbin being careful to leave the light weight beehive
shaped bobbin push spring inside the bobbin case.
of a TORO-4000 P
#
1.
Push the bobbin
(3) onto the bobbin winder shaft until it seats.
2.
As pictured, thread the sewing thread through the thread guide
#
(2) and around the tension post counter-clockwise, once, then
back out through the front thread guide.
3.
Wind the thread around the bobbin several times and push the
#
lever
(5) to the left to engage the bobbin winder.
As you are sewing the bobbin will begin to fill,
when the bobbin is filled, the latch will disengage
and the bobbin spindle and bobbin will stop.
#
4.
Loosen screw
(6) and adjust the bracket on lever
adjust the fill amount on the bobbin.
See Page 31 for
bobbin winding instructions
for the
TORO-3000 and TORO-4000 R machines.
.
5
#
(5) to