DK Digital CDB-700 Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Recording Equipment DK Digital CDB-700. DK Digital CDB-700 13 pages. Cd radio recorder

Print Page

Power supply

You can operate this device with the mains voltage of AC230V~ / 50 Hz, or with battery

power.

Mains operation

Connect the mains cord to a properly wired wall outlet with a voltage of AC230V~ / 50 Hz.

Now the device is operational.

Battery operation

Open the battery compartment on the rear side of the unit. Insert 8 x 1.5V UM-2 R14 „C" size

batteries (not supplied) into the compartment according to the insertion instructions in the battery

compartment. Observe the correct polarity of the batteries, as otherwise the device may suffer

damage. Due to their longer service life, we recommend you to use alkaline batteries. Close

the compartment again. Now the device is operational.

Batteries must not be thrown in the household waste. Please take used batteries

to the respective collecting points or take them there where you have bought the

new ones. Do not throw batteries into the fire.

Move the FUNCTION switch to choose the desired function.

"CD/USB/SD" for playback of CD, or from a USB/SD device, or

"RADIO" for radio reception, or

"TAPE (OFF)" for cassette operation.

To switch the unit off, move the FUNCTION switch to the „TAPE (OFF)" position.

With the VOLUME controller at the left side of the unit you can set the volume as requested.

Turn the controller clockwise to increase the volume. Turn it counter clockwise to lower the

volume.

If you would like to boost the low frequencies, press the DBBS button. Press the button

again to deactivate this function.

Headphone Operation

You can connect a headphone to the PHONES jack at the rear end left in the device using a

3.5mm jack plug. This deactivates the build-in speakers.

Be careful with regard to your hearing. A too high volume may lastingly impair the

hearing ability of your ears.