DK Digital AS-120 Owner's Manual - Page 9

Browse online or download pdf Owner's Manual for Home Theater System DK Digital AS-120. DK Digital AS-120 13 pages. Home theater surround system

Print Page

Installing the Battery

The remote control uses a pre-installed

lithium battery. To prevent an anticipated

discharge of the battery, we've inserted an

insulating strip. Please pull it out prior to first

operation.

Should the r/c start to work unreliably

replace the battery with a new one of the

same type. Open the battery compartment.

Push the retention clip in the direction of

arrow and pull out the battery mounting.

Before you take out the empty battery,

please memorise its position. The "+"

marking must show upwards, otherwise the

r/c will not work and may be damaged.

Replace the cover.

Batteries must not be disposed by ordinary refuse disposal. Please lead

empty batteries towards appropriate collecting points. Never throw batte-

ries into fire.

Please point the r/c towards the main unit when operating its buttons.

The r/c works properly in a distance below 5m and in an angle of up to 45°

of the front of the unit. No obstacles may stand in the way between r/c and

infrared sensor.

If you won't use the r/c for some time, please remove the battery from the

compartment, to prevent damage by leakage.

Operating the Home Cinema Set

1. Set the MAIN POWER switch at the subwoofer's rear panel to ON-position

(I). Now the unit is in operation mode and the indicator lamp at the front

panel lights up in blue.

2. Now press the 5.1 CH IN or STEREO button to select the desired input: 5.1

or STEREO.

3. When you've activated the STEREO input, you can choose the 2.1 CH mode

(stereo with subwoofer) or the 5.1 CH mode depending on the desired ope-

ration mode. Just hit the corresponding button. Accordingly the display

shows: 2.1 CH or 5.1 CH.

4. You can set the overall volume using the M. VOL +/- buttons of the r/c.

Press the M. VOL + button to increase volume, or press the M. VOL - but-

ton to lower the volume. The display shows the current setting from 0-50.

5. To adjust the loudness ratio between the speakers during normal operation

please follow like this: